I have built a MAP enhancer but I'm not sure about the hook-up. I have three wires coming out of the MAP enhancer. There is a ground wire, a wire coming from the toggle switch and a wire coming from two potentiometers with 33k resistors. Which wire gets hooked up to the signal wire from the MAP sensor and which one is hooked up to the wire coming from the ECU?
Appreciate any help!
 HHO Kit Reviews | HHO Generator | Gas Conversion Kits | Hybrid Water Cars | Hydrogen Fuel Cars | HHO Forum |
|
MAP sensor install
2 posts • Page 1 of 1
MAP sensor install
by kyle on Wed Apr 08, 2009 10:26 pm
- kyle
- Posts: 3
- Joined: Fri Feb 27, 2009 9:41 am
Re: MAP sensor install
by billhac on Wed Apr 15, 2009 7:59 pm
well if you built it right, then the wire from the switch should go the the map sensor side of the signal wire and the other should go to the ecu side of the signal wire when it is cut
- billhac
- Posts: 56
- Joined: Sun Mar 08, 2009 12:41 pm
2 posts • Page 1 of 1
 |
|
|
Who is online
Users browsing this forum: No registered users and 1 guest
Advertisements by Advertisement Management
